Skip to main content


Health

In a process similar to 3D printing, the material is deposited in layers. Each layer is exposed to ultraviolet light from a source attached to the pen, hardening the gel so further layers can be added, eventually building a three-dimensional framework.
141 of 1526




Newsletter Sign Up

Daily Readings

Reading 1, Jeremiah 1:1, 4-10
The words of Jeremiah son of Hilkiah, one of the priests living ... Read More

Psalm, Psalms 71:1-2, 3-4, 5-6, 15, 17
In you, Yahweh, I take refuge, I shall never be put to shame. ... Read More

Gospel, Matthew 13:1-9
That same day, Jesus left the house and sat by the lakeside, ... Read More

Saint of the Day

July 23 Saint of the Day

St. Bridget of Sweden
July 23: Saint Birgitta was the daughter of Upplandís Lagman, Birger ... Read More